Novexx Solutions XLP 504, Service Manual, Page: 130 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 09 130 Parameter Menu
• tightened xxx : Setup of the tightened dancer arm (xxx = actual sensor value).
The setting follows in both cases this scheme:
1. Bring the dancer arm to its loose position.
2. Press key 3.
3. Pull the dancer arm tight.
4. Press key 2.
Rewinder Values

Only with installed and activated „Rewinder 2000“ ( Options > Selection > Periph. device = „Rewin-
der“).
Shows the values of the position sensor at the rewinder dancer arm in middle/tightened and in loose
position.
• xxx = Sensor value in loose position
• text = Sensor type (Opto = light barrier; Hall = hall sensor; ???? = no explicit sensor type)
• yyy = Sensor value in middle position
A setting instruction for the external rewinder „Rewinder 2000“ can be found in the „User Manual
Rewinder 2000“, topic section „Attachement, Setup“, chapter „Setting up 64-xx / AP 5.4 / AP 7.t“ >
„Adjusting the sensor“.
Display mode

Only if Options > Selection > Periph. device = „Dispenser“.
Makes the number of already printed labels appear in the display instead of the number of the not
yet printed ones.
• Job rest quant. : Display of the not yet printed labels of a print job.

The counter keeps it´s value even after switching the printer off.
• Dispense counter : Counting of start pulses. Activate the counter by selecting "Dispense coun-
ter". The counted number appears on the display after the parameter Dispense counter (see
below) has been selected.
Dispense counter

Only if
Options > Selection > Periph. device
= „Dispenser“
xxxxxx = Number of dispensed labels.
Setting range Default setting Step width Easy Plug
-- -- -- --
Rewinder values
xxx <----- text ------> yyy
Settings Default setting Step width Easy Plug
Job rest quant., Dispense counter -- #PC2004
Setting range Default setting Step width Easy Plug
-- -- -- #PC2005
Dispense counter
xxxxxx