Novexx Solutions XLP 504, Service Manual

Page: 126 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 09 126 Parameter Menu
Cut width

Only with mounted and activated cutter (
Options > Selection > Periph. device
= „Cutter“).
The values for MAX_CUT_WIDTH depend on printer type and print head:

The values for MAX_CUT_WIDTH don´t equate to the real cut width (no linear relation between
value and cut width). The proper setting value has to be determined by trying.
Cut position

Only with mounted and activated cutter (
Options > Selection > Periph. device
= „Cutter“).
The cut position is identical to the detected gap position, i. e. with the start of the label.
This parameter can be used for fine settings to meet specific customer requirements.
• Maximum offset in feed direction: -5,0 mm
• No offset: 0 mm
• Minimum offset against feed direction: +5,0 mm
Double cut

Only with mounted and activated cutter ( Options > Selection > Periph. device = „Cutter“).
Joining grids or the gap area between the labels can be removed using a double cut, thereby im-
proving the outline.
The first cut is offset by the distance set from the recognized gap position away in the feed direction,
the second cut is made at the gap position.
A possible correction of the cut position ("Cut position" function) is calculated for both cuts and
must be taken into consideration.
Normal simple cut: 0,0 mm

The smallest possible double cut distance of 1.0 mm must be adhered to!
Rest position

Only with mounted and activated cutter ( Options > Selection > Periph. device = „Cutter“).
To avoid that the label material is wrapped around the print roller after a long idle time, the material
rest position can be changed to „at cutter“.
Setting range Default setting Step width Easy Plug
[0...MAX_CUT_WIDTH] MAX_CUT_WIDTH -- #PC1016, #CW
Printer MAX_CUT_WIDTH
XLP 504 with 203 dpi 104
XLP 504 with 300 dpi 105
XLP 506 with 203 dpi 168
XLP 506 with 300 dpi 168
Setting range Default setting Step width Easy Plug
[-5.0...5.0] mm 0 mm 0.1 mm #PC1017
Setting range Default setting Step width Easy Plug
[0.0...5.0] mm 0.0 mm 0.1 mm #PC1018, #ER
Settings Default setting Step width Easy Plug
at head, at cutter at head -- #PC1041