Novexx Solutions XLP 504, Service Manual

Page: 121 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 09 121 Parameter Menu
Error polarity

Only with an I/O board mounted.
Switches the polarity of the ERROR signal
• Level high activ : The output is high when it is active, otherwise low.
• Level low active : The output is low when it is active, otherwise high.
Status output

Only with an I/O board mounted.
This parameter defines different events, which activate the output signal MACHINE STATUS.
• Foil end warning : The signal is activated, if the ribbon roll diameter is less than the limit..
See parameter Foil end warning

on page 141.
• Print job ready : The signal is activated, if the printer has finished image processing and is ready
to start printing.
The signal is not activated, if:
– the print job is done,
– the print job was stopped,
– the printer was switched to offline mode,
– the printer is in pause mode.
Status polarity

Only with an I/O board mounted.
Switches the polarity of the MACHINE STATUS signal.
• Level high activ : The output is high when it is active, otherwise low.
• Level low active : The output is low when it is active, otherwise high.
End print mode

Only with an I/O board mounted.

Not available in batch mode.
Concerns the output signal PRINT_END at the I/O board signal interface. Determines the signal
response after printing of a label.
Settings Default setting Step width Easy Plug
Level high activ, Level
low active
Level low active -- #PC3208
Settings Default setting Step width Easy Plug
Foil end warning, Print
job ready
Foil end warning -- #PC3209
Settings Default setting Step width Easy Plug
Level high activ, Level
low active
Level low active -- #PC3210
Settings Default setting Step width Easy Plug
Mode0 inactive, Mode1 low
level, Mode2 high level, Mo-
de3 low pulse, Mode4 high
pulse
Mode0 inactive -- #PC3211