Novexx Solutions XLP 504, Service Manual

Page: 120 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 09 120 Parameter Menu
• Off : Signals at the FEED input are ignored.
• On : Feeding of one label on the falling signal edge. The display shows „I/O board feed“ during
feeding.
Requirements are:
– Offline mode or „stopped mode“ or „I/O pause mode“.
– Online mode and no print job loaded.
Pause input

Only with an I/O board mounted.
Concerns the input signal PAUSE at the signal interface.
• Off : Signals at the PAUSE input are ignored.
• Pause : A high-to-low transition switches the printer into the “I/O-Board Pause” mode. The next
high-low-transition switches the printer back into the online mode. If parameter
Options > I/O Board
> Start print mode
is set to „Level high active“ or „Level low active“, any activating of the PAUSE
signal stops the printing after the current label
Features:
– Printer display shows „I/O-Board pause“
– ERROR is active (only if
Options > I/O Board > Error output = „ PrinOffl“ )
– If a print job is available: DATA READY becomes inactive (if Options > I/O Board > Status output
= „ Print job ready“ )
– START PRINT signals are suppressed
– REPRINT requests are processed after switching into online mode
Error output

Only with an I/O board mounted.
This parameter defines different events, which activate the output signal ERROR.
• Printer error : ERROR will be activated in all of the following cases:
– Material end
– Ribbon end (only if
Print > Material > Foil mode
= „Thermo transfer“)
– No punch recognized (only if
Print > Material > Materialtype
= „Punched“)
– Print head pressure lever was opened during the printing of a label.
– Start print error
– Other errors, which keep the printer from printing

During the initialization (powering up) of the printer, the ERROR-signal is instable!
• PrinOffl : In addition to the above mentioned cases avtivate the following events the
ERROR-signal:
– The printer is in offline mode
– The print head pressure lever is open
– „I/O board pause“ mode
– Stopped mode (the printing was stopped)
Settings Default setting Step width Easy Plug
Off, Pause Off -- #PC3012
Settings Default setting Step width Easy Plug
Printer error, Printererr
+Offl
Printer error -- #PC3207