Novexx Solutions XLP 504, Service Manual, Page: 112 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 09 112 Parameter Menu
Materialtype
Definition of the used label material. A distinction is made between endless material and gapped
material (hole gaps, self-adhesive material with register gaps). The detected gap position corre-
sponds to the start of the label.
• Endless : If material is to be used without gaps
• Punched : If material is to be used with gaps

The value is overwritten by the appropriate Easy Plug command when sending label formats.
Materiallength
The material length (label length) is the distance between the gaps, measured from the front edge
(beginning) of a label to the front edge of the next label.

The value is overwritten by the appropriate Easy Plug command when sending label formats.
Materialwidth
Zero position of the left border. If the printer is working in line-printer mode, alterations can be made
in millimetre units.
Punchmode
• Auto negotiation : Automatic mode, for material with a contrast zone = gap in the label.
Suitable for all materials with which there is a difference in the transparency between the label
and gap of more than 2 values (see Description, sensor check).
The range of the value automatically measured by the gap detection can be defined specifically
for the label material. This allows materials with high-contrast proof points within the label to be
processed, which would otherwise be measured as 'false' gaps by the system. The correspon-
ding setting value is then equal to, or smaller than, the value measured at the actual gap.
• Manual : Manual setting, for material with several varying contrast zones. Settings are made
using the parameter Print > Material > Punchlevel .
Settings Default setting Step width Easy Plug
Endless, Punched Punched -- #PC1005, #IM
Settings Default setting Step width Easy Plug
[5...max. label length
a
]
a) The max. label length depends on several factors, e. g. the memory configuration.
100 mm 0.1 mm #
Settings Default setting Step width Easy Plug
6,0...max. width
a
a) The max. width depends on several factors, e. g. the memory configuration.
100 mm 0.1 mm #IM, #PC1007
Settings Default setting Step width Easy Plug
Auto negotiation, Ma-
nual
Auto negotiation -- #PC1022