06/15 Rev. 6.01-01
OPERATOR / SERVICE MANUAL
Safety Notes
U-RX
3
Machine operating safety
Conditions for safe use
Only use the machine in enclosed areas with environmental conditions matching the
values given in the technical specifications.
Only operate the machine on a plane, solid support.
Only trained and authorized personnel should operate the printer!
Do not make any modifications or any additional casing for the machine!
Do not allow any liquids to enter into the machine!
Repairs to the machine may only be performed by authorized specialists who are
aware of the risks involved!
Make sure that the power supply socket for the machine is readily accessible!
Lay the power supply cable, data cables in a way that nobody can stumble over it.
In case of emergency, switch off the machine and pull off the power supply cable!
Only use original accessories!
Protect against injuries that can result from
electrical current
Only put the machine into operation when installed in a correctly installed housing.
Only operate the machine using the system voltage indicated on the nameplate!
Assure, that the voltage, which is set at the device, matches the local mains voltage!
Only connect the machine to a grounded power socket fitted to authorized standards!
Only connect devices to the interfaces at the machine that fulfil SELV (safety extra-low
voltage) circuit requirements according to EN 60950!
Protect against injuries that can result from
mechanical actions
Don´t wear
loose
long hair (if necessary, wear a hairnet).
Keep loose jewellery, long sleeves, etc. away from rotating parts or the printer.
Wear sufficient personal protective equipment.
