06/08 Rev. 4.05-01
USER MANUAL
Setting up
TTX
x50/67x
–
Wildcats/Wildcats plus
–
S 45/65/95/105
–
TDI/STDI/XXTREME
5
Inserting material
1. Open the lid of the device.
TTX / Wildcats
2. Pull off the outer guide disk (1) of the
unwinder (2).
3. Place material with the corresponding
adapter rings on the unwinder.
The roll of material should rotate anti-
clockwise while unwinding.
4. Attach the outer guide disk of the
unwinder.
5. Lay material around the dancer arm.
6. Depress the red lever (3) of the intake to
raise the nip rollers slightly. With the
lever (3) depressed, push the start of the
material through the material guide until
it is under the print head.
7. Align the material so that it is taken in
straight. Position the nip rollers of the
print unit after depressing the lever (3)
so that both rollers are sitting
symmetrically on the material. Let go off
the lever (3) again.
Do not press your free hand against the
print module! The cutter (optional) could
cause injuries if the keys are
operated incorrectly.
There is a danger of fingers,
hair, clothing, jewellery etc. being caught
up in the intake area of the transport
unit.
1
2
3
