01/13 Rev. 5.05-01
USER / SERVICE MANUAL
Mounting and setting the LTSI
LTSI
Setting the Applicator
9
Setting the Applicator
„Must“-parameters
„Can“-parameters
WARNING!
Danger of getting hands crushed at the following locations:
• Between applicator pressure plate and printer dispensing edge.
• Between applicator pressure plate and conveyor (if applicable).
During operation, keep your hands away from the moving area of the applicator.
Switch off the printer before any servicing or repair work.
Parameter
Setting
DISPENSER PARA > Start source
USI
DISPENSER PARA > Dispensing edge
long
DP INTERFACE > Interface type
USI applicator
DP INTERFACE > Start print mode
Level low active
a
a)
This setting is imperative, if parameter
DP INTERFACE > Apply mode
is set to
„After start sig.“
DP INTERFACE > End print mode
Mode 1
DP INTERFACE > Internal inputs
Enabled
[Tab. 2] These parameter settings are imperative for the printer
operation with an applicator.
Parameter
DISPENSER PARA > Application mode
DP INTERFACE > Start print mode
a
a)
This setting is only arbitrary, if parameter
DP INTERFACE >
Apply mode
is set to „After print“.
DP INTERFACE > Apply mode
[Tab. 3] These parameters can be used to adapt the applicator ope-
ration to the application.
