Novexx Solutions ALX 92x, Service Manual

Page: 743 / 824

04/16 Rev. 11 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
54
5201 Touch down
Status The applicator did not reach its touch down position within the given time
frame.
Measure

Check cable and compressed air connections; reconnect them properly, if
necessary.
 May the applicator move unhindered? – remove any obstacles.
5203 Touch down sens.
Status The touchdown sensor(s) was/were already triggered before the
application.
Measure

Check cable and compressed air connections; reconnect them properly, if
necessary.
5204 Appl. Starterror
Status The device received another start signal during printing/applying a label.
Precondition: Parameter
APPLICATOR PARA > Start error stop
or
DP INTERFACE > Start error stop is set to On .
Measure

Check the labelling procedure; increase the product distance.
 Set parameter Start error stop to Off .
5205 Applicator gen.
Status General software error
Measure

Please read the notes in section General software errors  .
5206 Applicator resp.
Status Communication with the AI exceeded a given time frame.
Measure  Switch the printer off and on again after half a minute. If the error still
occurs after several trys, please contact our technical support.
5207 Appl. driver 1
Status Shortcut or overheat at power output 1 at the applicator connector (CN603)
on the AI board. The power output 1 comprises the following output signals:
•
Cylinder
•
Vacuum
•
Airstream Support
•
Blow On
Measure

Check the connections.