Novexx Solutions ALX 92x, Service Manual

Page: 706 / 824

04/16 Rev. 11 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
17
1115 > Limit value
Status A sent Easy Plug command contains a value which exceeds the admissible
range at the top limit. The faulty value is replaced automatically by a default
value matching the limits.
Example: #YT109/5/. The value 5 has been assigned to the parameter d.
Admissible for d are the values 0, 1, 2, 3. Therefore, 5 exceeds the value
range at the top limit.
Measure  Check the Easy Plug command on admissible values and correct them if
necessary.

Please read the notes in section Easy-Plug errors  .
1120 Incorr. logo no.
Status Logo no. is invalid because it is outside of the address field. (self-
acknowledging)
Measure

Check whether the logo no. has been given as being smaller than 0 (zero)
or larger than 255.
1121 Logo exists
Status Logo already exists.
Measure  Change the designation of the logo; repeat saving.
1122 Creating logo
Status General software error
Measure

Please read the notes in section General software errors  .
1123 Rename logo
Status General software error
Measure  Please read the notes in section General software errors

.
1124 Logo file
Status General software error
Measure

Please read the notes in section General software errors  .
1125 Delete error
Status General software error
Measure  Switch printer off and then back on again after thirty seconds.

Please read the notes in section General software errors  .