Novexx Solutions ALX 92x, Service Manual, Page: 661 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
139
KCE 4Inch
Printhead Kyocera KCE, 4" width, is applied in the following printer types:
64-04, DPM 4“, PEM 4“, ALX 924
Sensor type
PEM ALX 73x (PMA)

Only in production mode.
Combined sensor Required setting, if the printer is equipped with a combined reflex/punch
sensor.
Standard
Required setting, if the printer is equipped with separate light sensors for
reflex marks or gaps.
Disp. Head Offs.
64-xx

Only with 64-xx dispenser equipped with a 4“ printhead.

Only in production mode.
Dispenser Head Offset
Yes Setting required for 64-04 dispenser with 4“ printhead: At the inner side end
of the printhead exists a non-printable area of 13 mm width.
No
Setting required for 64-05 dispenser with 4“ printhead: Full 4“ print width with-
out restrictions. Precondition: The printhead is positioned at least 13 mm
away from the innner side printhead end.
Default Values
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6

Parameter appears only in production mode.
User defined
The presently selected settings of all parameters will be taken as default val-
ues. That is you will get those settings back even after a firmware update. All
you have to do is to call the parameter "Factory settings".
Standard Calling the parameter "Factory settings" will set all parameters to the factory
preset values.
Command sequence
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6

Parameter appears only in production mode.
~
„~“ is used as start sign for Easy-Plug command sequences.
#
(Default setting) „#“ is used as start sign for Easy-Plug command sequences.