Novexx Solutions ALX 92x, Service Manual, Page: 627 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
105
Transport mode
64-xx

Only if
SYSTEM PARAMETER > Periph. device
= „Dispenser“.
In normal operation mode, the rewinder motor (Dispenser Motor) feeds the
material, while the feed motor runs idle. When applying very slim material, it
can be advisable to add the power of the feed motor in order to prevent ma-
terial rupture (Dual Motors). To run the printer like a usual non-dispenser, the
rewinder motor can be switched off (Printer Motor).

Absolutely use the "Dual Motors" mode, if the following three conditions
are the case:
•
Printer is used as dispenser
•
Ribbon autoeconomy mode switched on
•
Print speed higher than 203 mm/s (8 inch/s)
Printer Motor
Rewinder motor switched off. The printer behaves like a model without dis-
penser option.
Dual Motors Both motors (feed and rewinder) are activated.
Dispenser Motor The feed motor is switched off. The rewinder motor feeds the material (De-
fault setting).
Calibration mode
AP 5.4 AP 5.6

Only if
SYSTEM PARAMETER > Periph. device
= „Dispenser“.

Is only effective with label material shorter than 40 mm!
If label material shorter than 40 mm is used, the printer automatically in-
itializes before printing. This measuring of the label material improves
the impression accuracy. The initialization occurs in the following cases:
•
After switching the printer on
•
After opening and closing the printhead pressure lever.

Advice : Start the material initialization manually before printing. This is
done by pressing the feed button in offline mode.
Selecting a material initialization procedure:
Automatic
(Default) Material initialization is done automatically. Therefore, the label ma-
terial is fed forwards and backwards several times.

There is a risk of the dispensing edge roller getting jammed by labels
sticking to it, which were dispensed by the forward/backward movement. If
this happens, use the setting „Manual“ instead.
Manual
The label material is fed two or three label lengths forwards. If this is done,
dispense two labels by pressing the feed button - only afterwards, the initial-
ization is complete.
Start offset
64-xx ALX 92x DPM AP 5.4 AP 5.6