Novexx Solutions ALX 92x, Service Manual, Page: 625 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
103
Dispensing mode
64-xx ALX 92x DPM PEM

Only if
SYSTEM PARAMETER > Periph. device
= „Dispenser“.

Only effective in real 1:1 mode!
Real 1:1 mode normally bears the disadvantage of a slightly lower impression
accuracy, caused by the additional slippage at the rollers while feeding back.
The parameter "Dispensing mode" enables optimal positioned printouts even
in real 1:1 mode. This accuracy is reached by feeding back the next label to
be printed behind the gap sensor instead of "only" as far as under the print
head. The additional distance of backwards feeding reduces the output rate
slightly.
exact Printout with a maximum impression accuracy
fast
(Default) Printout with a lower impression accuracy but higher output rate.
Application mode
64-xx ALX 92x DPM AP 5.4 AP 5.6

Only if
SYSTEM PARAMETER > Periph. device
= „Dispenser“.
Save Mode
A start signal is required to draw the next label back under the print head. This
setting bears advantages for label material with a strong adhesive, which
would not stay attached to the applicator when the backing paper is fed back-
wards.
Immediate Mode
After the just printed label has reached the dispense position, the following
label is drawn back under the print head. The dispensed label stays attached
to the applicator (default setting).
Synchronous mode Drawing back of the next label to be printed is triggered by the not active edge
of the start signal. The active edge is defined with
Start print mode
. Not active is
the opposite signal edge.
Requirements:
•
USI:
– USI firmware version: 7 or higher
–
DP INTERFACE > Start print mode
= „Pulse rising“ or „Pulse falling“
•
AI:
APPLICATOR PARA
> Start print mode
= „Pulse rising“ or „Pulse falling“
•
SYSTEM PARAMETER
> Start print mode
= „Pulse rising“ or „Pulse falling“
•
With I/O board installed: I/O BOARD PARA
> Start print mode
= „Pulse rising“ or
„Pulse falling“
•
SYSTEM PARMETER > Signal edge = „Rising edge“ and
SYSTEM PARAMETER > Start mode = „Edge“
•
With I/O board installed:
I/O BOARD PARA
> Start print mode
= „Pulse rising“ or
„Pulse falling“