Novexx Solutions ALX 92x, Service Manual, Page: 614 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
92

Detailed information about using start signals can be found in the user man-
ual, topic section „Advanced Applications“, chapter „Printing with start sig-
nal“,
Settings in the parameter menu 

Only appears here, when no I/O board is installed. Otherwise, this
parameter appears in the
I/O BOARD
menu.

For details see paragraph Start print mode

on page 122.
Start print mode
64-xx ALX 92x DPM PEM AP 4.4 AP 5.4
Selecting a print mode. Depending on the selected mode, a start signal at the
single-start input will be interpreted differently.

Information about using the start signal: see user manual, topic section „Spe-
cial applications“, chapter „Printing with start signal“.
Pulse fall/ris
The printing of a label is triggered by a low-high-change as well as by a high-
low-change of the start signal. The printing occurs only after the set delay
time.
Level high activ Labels are being printed as long as the start signal is held high.
Pulse rising The printing of a label is triggered by a low-high-change of the start signal.
The printing occurs only after the set delay time.
Level low active
Labels are being printed as long as the start signal is held low.
Pulse falling (Default setting) The printing of a label is triggered by a high-low-change of
the start signal. The printing occurs only after the set delay time.
Apply key
64-xx ALX 92x DPM PEM

64-xx: Only if
SYSTEM PARAMETER > Periph. device
is set to „Dispenser“.

Parameter is displayed in production mode only.

Only if
SYSTEM PARAMETER > External signal
is set to „Singlestart“
On
(Default) The application can be triggered by pressing the cut respectively
apply key.
Off Triggering the application by pressing the cut/apply key is not possible.
Print contrast
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
xxx% Setting range: 1 to 110 120 %; Unit interval: 1; Default setting: 60