Novexx Solutions ALX 92x, Service Manual

Page: 612 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
90
Some applications with high print speed and/or small labels have shown that
the imprint accuracy differs, depending on if there is a print stop between two
labels or not. The function „Head lift automatic“ lifts the printhead between all
labels for a short time and thus provides a more regular imprint accuracy.

The function reduces the label throughput, because each head lift needs
about 80 ms time.
Off
Head lift automatic is switched off.
On Head lift automatic is switched on. The printhead is lifted automatically after
each printed label.
Mat.end detect.
64-xx ALX 92x DPM PEM ALX 73x (PMA)
Material end detection.
The material end detection can be deactivated for processing labels with
gaps longer than 15 mm, or if using material with a high fluctuation in light
transparency (Status message „5002 material end“ is displayed even though
material is present).
Reflex
Material end detection by means of a reflex sensor.
Transparent
Material end detection by means of a transmission sensor.
Off No material end detection.
Periph. device
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4
AP 5.6
After installation, options must be selected under "Peripheral device" in order
to be assured of the corresponding sensor queries and printer reactions.
None No peripheral device is installed.
Cutter Sets the printer firmware to the cutter option. Selection permits access to the
cut parameters.
Rewinder
Sets the printer firmware to the rewinder option. Selection permits access to
the rewinder setting parameters.
CAUTION!
Soiling or damaging the print roller.

Endless (= not converted) material should not be processed when the ma-
terial end detection is deactivated (otherwise, printing is continued on the
print roller after material end).
CAUTION!
Selecting an incorrect option can lead to malfunctions or damage.