Novexx Solutions ALX 92x, Service Manual

Page: 599 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
77
SYSTEM PARAMETER
Speed unit
ALX 92x DPM PEM
The print or feed speed can optional be set in mm/s or in inch/s.
mm/s
Set speeds in mm/s
Inch/s Set speeds in inch/s (default)
Cover open error
64-xx ALX 92x DPM PEM
Defines, when the status message „Cover open“ appears:
Immediately
(Default) Status message appears immediately after opening the hood.
If material feed
(Default for 64-xx) Statusmessage appears if the hood is open and material
feed is supposed to start.
Foil end warning
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
Setting of a limit diameter for the ribbon roll. If the ribbon roll diameter falls
below the set value, the displayed message changes from…
64-xx, DPM / PEM, ALX 92x:
Additionally to the display message, a signal is set at the (optional) USI.

For details refer to the parameters
DP INTERFACE > Ribbon signal
and
SERVICE DATA > OPERATION DATA > Foil diameter
x.xx mm Setting range: 25.4 to 50.0 mm; Unit interval: 0.1 mm;
Default setting: 25.4 mm
Foil warn stop
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
Off
(Default setting) Printer does not stop in case of a „Foil end warning“.
On
If a „Foil end warning“ occurs, the printer stops after the current label and
shows the status message:
5003
ONLINE X JOBS …to…
FOLIE X JOBS …while the display is blinking.