Novexx Solutions ALX 92x, Service Manual, Page: 456 / 824

06/15 Rev. 02 SERVICE MANUAL Firmware
64-xx Gen. 2 – DPM Gen. 2 – ALX 92x Gen. 2
4
Taking over parameter settings
Beginning with firmware 4.0, the parameter settings of the printer are saved.
This keeps the parameter settings even in cases, where the new firmware
provides a modified structure of the parameter menu.
During the first system start after loading the new firmware, the following
message appears:
Afterwards, the system restarts automatically.

Taking over the parameter settings does not work, if the firmware was
loaded with the bootloader.
H8_Rhapsody.s3b
•
Part of the firmware responsible for the H8 system.
•
In former firmware versions: H8.s3b
RISC.s3b Part of the firmware responsible for the 64 bit system.
SPD_3.s3b Speedo fonts (starting with version 4.10, those fonts
are integrated in the firmware file and are therefore no
longer available as separate file)
AVE256.s3b Fix fonts (starting with version 4.10, those fonts are
integrated in the firmware file and are therefore no
longer available as separate file)
USI_Vx.s3b
•
Firmware for the USI interface
•
Can be updated the same way as printer firmware,
if the printer firmware is at least version 4.31.
•
See topic section Service Electronics

, chapter
„USI board“
AI_Vx.xx.s3b
•
Firmware for the Applicator Interface (AI).
•
Can be updated the same way as printer firmware,
if the printer firmware is at least version 4.31.
•
ALX 92x / DPM: see topic section Applicator
Interface

, chapter „System requirements“.
Param. Recovered
File Description
[Tab. 2] Files supplied with the firmware.