Novexx Solutions ALX 92x, Service Manual

Page: 427 / 824

06/16 Rev. 04 SERVICE MANUAL Service Electronics Gen. 3
64-xx Gen. 3 – DPM Gen. 3 – PEM – ALX 92x Gen. 3 – ALX 73x (PMA)
58
Assembling the OD-sensor
1. Remove rear hood, see topic section
Service Mechanics

, chapter „Rear hood
(ALX)“.

For operation with an AI, the connection
cable may have to be replaced before as-
sembling the sensor, see chapter
Connec-
ting the OD-sensor to AI

on page 60.
2. Fix OD bracket [39A] and cable clamp
[39B] to the base plate with a M4 hexagon
socket screw and shim [40].

Insert aluminium disc [40A] between brac-
ket and base plate!

Attach cable clamp to the marked point on
the cable!

Ensure sufficient distance is retained bet-
ween the light barrier sensor cable and the
material guide plate!
3. Ensure that the holding plate has the
characteristics described in [41].

The threaded holes [41A] for the wing
screw are only implemented from the follo-
wing delivery date/serial number:
– ALX 924: 05/2002
– ALX 925: 05/2002
– ALX 926: 0358610204-ALX926

The holding plate with threaded holes and
counter bore can be ordered under the or-
der number A2794 for fitting onto older ma-
[39] Fixing the OD check system.
A Bracket
B Cable clamp
C M4 hexagon socket screw
[40] Sequence of assembly on the OD bracket:
A Aluminium disc
B Bracket
C Cable clamp
D Disc
E Screw
[41] The material roller holding plate must have the following
characteristics:
A Threaded holes
B Counter bore (material unwinder axle must be fixed with
a countersunk screw)
B
A
C
C
A
B
D
E
B
A A