Novexx Solutions ALX 92x, Service Manual, Page: 31 / 824

07/15 Rev. 03 SERVICE MANUAL Unpacking and assembling the machine
ALX 92x
5
Mounting the machine on a support
stand
Prerequisites:
• Support stand with a tube end providing the follow-
ing measures:
– Outer-Ø: 60 mm
– Wall thickness: minimum 5 mm
• Second person to hold the machine during installa-
tion
Tools:
8/10 mm allen keys
Assembly:
The machine is delivered with the head joint bent
downwards [5].
1. Loosen the screws [5A].
2. (1
st
person) Push the machine with the head joint
onto the support stand tube and hold it there.
3. (2
nd
person) Tighten the clamp screws [6A] and
[6B].

Tightening torque: 45 Nm
Aligning the machine:
1. (1
st
person) Hold the machine.
2. (2
nd
person) Loosen the clamp screws [6A][6B].
3. (1
st
person) Adjust the machine position.
4. (2
nd
person) Tighten the clamp screws [6A] and
[6B].

Tightening torque: 45 Nm
WARNING!
Risk of injury from a tipping over support
stand.
 When installing the machine on a support
stand, make sure that it can not tip over.
 Fix the support stand onto the ground.
[5] Head joint in the state of delivery.
[6] Mounting to the support stand.
A
B
A
B