Novexx Solutions ALX 92x, Service Manual, Page: 273 / 824

06/16 Rev. 09 SERVICE MANUAL Service Mechanics
DPM – PEM – ALX 92x
75
Overview of printhead settings
There are electronic and mechanical prin-
thead settings:
Electronic
settings Parameter When required?
Print contrast SYSTEM PARAMETER >
Print contrast
a
a) Oder, im Online-Modus: Prog-Taste.
Blackening of the printout is too low (depends on
material/ribbon combination)
Printhead
resistance
SYSTEM PARAMETER >
Head resistance
After each printhead exchange.
Printhead
temperature
compensation
SYSTEM PARAMETER >
Temp. reduction
Label layout with huge areas of blackening and
smearing of tiny structures, see user manual, topic
section „Advanced Applications“, chapter
Printing
with temperature compensation on page 2.
[Tab. 3] Electronic printhead settings.
Mechanical settings When required?
Adjusting the printhead position After printhead exchange, if the printout is
considerably worse, see chapter
Adjusting the
printhead position on page 81.
Adjusting the printhead contact
pressure After removal of the printhead contact pressure lever,
see chapter
Adjusting the printhead contact pressure
on page 82.
Adjusting the printhead gap After removal of the printhead motor, see chapter
Adjusting the printhead gap on page 78.
[Tab. 4] Mechanic printhead settings.