Novexx Solutions ALX 92x, Service Manual

Page: 105 / 824

04/16 Rev. 06 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x
30
Printer setup
1. Insert the WLAN CF card into the printers card slot. Switch the printer on.
In the printer menu
INTERF. PARAM. > NETWORK PARAM.
, additional parameters for
WLAN operation show up.
The LED at the card is flashing as long as the card is not logged in at the access
point.
2. Make the following settings in the
INTERF. PARAM. > NETWORK PARAM.
menu:
3. Set parameter
INTERF. PARAM. > EASYPLUGINTERPR > Interface
to „LPD Server“.
4. Restart printer to activate the settings.
Connecting
1. Connect the access point to the PC using a crossed link cable. Connect the ac-
cess point to the mains supply and switch it on.
2. Check, if the LED at the WLAN CF card lights up permanent. If it does not, check
the following points:
– Is the card plugged firmly into the card slot?
– Does the card match one of the supported card types?
– Is the parameter
INTERF. PARAM. > NETWORK PARAM. > WLAN SSID
set to „idt“
(small letters!)?
CAUTION! - Network manipulations can disturb or avoid proper network operation.
 Before connecting any device to a network, always ensure the approval of the net-
work administrator.
Parameter Setting Note
IP addressassign Fixed IP address
IP address
e. g.
192.168.000.999
ask the network administrator for it;
the initial three bytes must equal
the PC address
Net mask 255.255.255.000 = default setting
WLAN SSID idt use lower case letters
WLAN WEP disabled
WLAN default key 0 or any other setting
FTP server arbitrary setting
WEB Server arbitrary setting
[Tab. 21] Required parameter settings in the printer menu.