Novexx Solutions ALS/XLS 204, Service & Installation Manual

Page: 79 / 312

Service Manual
ALS/XLS 20x/256/272
02/2019 | 02 79
9) Only appears, if Interface mode = „PLC signals“
10)Only appears, if Interface mode = „Applic. signals“
11)Only appears if Applicator type = PEP, „PEP Blow on“, „Reverse PEP“, BTS or „LA-TO Timed“
12)Does not appear if Applicator type = „LTP - LTPV“, PEP, „Direct Dispense“, „LA-TO Sensor“ or „LA-TO Timed
13)Does not appear if Applicator type = ASA, „Direct Dispense“ or LA-BO
14)Only appears with AI board installed
and if Interface mode = „Applic. signals“
15)Only appears with AI board installed and if Interface mode = „PLC signals“
16)Only appears with AI board installed
17)Only appears if remote display is connected
19) Only with ALS/XLS 256 and ALS/XLS 272
20)Only appears if Applicator type = „LTP - LTPV“, „PEP II Sensor“, „LA-TO BO Sensor“, „O-ring applicat.“ or „LA-TO Sen-
sor“
SIGNAL INTERFACE (continued) SERVICE/DIAGNOS. SERVICE DATA (continued)
Interface mode >AI BOARD SIGNAL
14
Service >MODULE FW VERS. Work place
>PLC SIGNALS
9
Applicator type Serv. data reset System version Company name
End dispense mod Apply mode Sensor Test System revision
Disp. end delay Start mode PS registers
19
System date >DISPLAY DATA
End pulse width Dwell time
11
Memory card test Applicator int.
16
Display Version
Blow on time
12
Test functions Display serialNr
>APPLIC. SIGNALS
10
Restart delay Store diagnosis >OPERATION DATA Remote disp.vers
17
Applicator type Position timeout
13
Gen.Support Data Service operations Remote disp. ##
17
Status outputs Apply comp. time Data blocks del. Tot. mat. length
Apply mode Touch down sens.
20
Dispensing cycl. >MEMORY DATA
Dwell time
11
TouchDownTimeout
20
Operation time RAM memory size
Blow on time
12
Total Operation Flash mem size
Restart delay >AI BOARD SIGNAL
15
Custom defaults
Position timeout
13
Status signals >POWERSUPPLYDA-
TA
Apply comp. time Type
Touch down sens.
20
>ACTIVE INPUTS Version
TouchDownTimeout
20
Start signal Serial number
Inhibit signal PS Temperature
OD sensor signal On time
>CPU BOARD DATA
CPU identifier
PCB Revision
FPGA version
MAC Address
Serial number
Production date
PCB part number
Board part numb.
Manufacturer
[Tab. 11] Overview of functions in the functions menu – part 2 (grey shading = only appears in production mode).