Operating Manual
LA-BO
Fig. 15: Adjusting the bars in the vacuum grid by matching the outside section of the sliding bars with the label surface.
Adjusting the air nozzles in the vacuum grid
To achieve optimal labelling apply accuracy it is important to adjust the blow-off air flow in the center of
the label under the vacuum grid. Therefore the air nozzles of the LA-BO can be fine adjusted in the X
(width) and Y (length) direction in reference to the label area.
To adjust the air nozzles in X-direction (width of label)
► Turn the black lower-right knob (A) clockwise or counter clockwise until the sliding bars / nozzles
are centered over the width of the label.
This setting becomes more critical for smaller label sizes. If the non-closed nozzles are not centered
over the width of the label, the label will move sideways during the blow-on action.
Fig. 16: Adjusting the air nozzles across feeding direction.
Edition 05 - 08/2022
28
Startup
Adjustments to the label material
