Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5, Installation Manual, Page: 60 / 76

60 ZENworks Endpoint Security Management Installation Guide
no
vd
ocx
(e
n)
17
Sep
te
m
be
r 20
09
Figure 8-7
Select the MSI package to add
8.2.1 Command-line Variables
Command-line variable options are available for MSI installation. These variables must be set in the
executable shortcut that is set to run in administrator mode. To use a variable, the following
command-line must be entered in the MSI shortcut:
“...\setup.exe” /a /V"variables"
. Enter any of the commands below between the quotation
marks. Separate multiple variables with a single space.
Example:
setup.exe /a /V"STDRV=stateful STBGL=1"
creates an MSI package where the
Endpoint Security Client 3.5 will boot in All Stateful with strict white-listing enforced.
NOTE: Booting in stateful can cause some interoperability issues (DHCP address delays, Novell
network interop issues, and so forth).
The following command line variables are available:
Table 8-1
Command Line Variables
Command Line Variable Description Notes
STDRV=stateful NDIS driver all stateful at boot time. Changes the default state of the
NDIS driver from All Open to All
Stateful permitting all network traffic
at boot time, until the Endpoint
Security Client 3.5 has determined its
location.
/qn Quiet install. Use to suppress the typical MSI
Installation process. Endpoint
Security Client 3.5 will activate at next
user reboot.