Novell ZENworks 10 Configuration Management Asset Inventory, Reference Manual, Page: 54 / 144

54 ZENworks 10 Configuration Management Asset Inventory Reference
n
ov
do
cx (e
n)
16
Ap
ril 20
10
that file or path. If a file or path is specified in the Files and paths to exclude from
collection field, all files and paths are searched except the specified file or path. Paths
specified in the Software Applications panel are also skipped.
NOTE: If you are specifying a path, you must include a trailing backslash (\). For
example, if you want to include all
.exe
files in the
dir
directory, type
C:\dir\
.
8 In the Advanced panel, configure diagnostic settings.
WARNING: These options are intended for advanced diagnostics. Use them only under the
guidance of a Novell Support representative.
9 In the Collection Servers panel, use the Move Up and Move Down buttons to arrange the
collection servers.
This arrangement determines the order in which the collection servers receive the inventory
data.
10 Click Apply or OK .
3.2 Scheduling an Inventory Only Scan
This section shows you how to schedule an inventory scan for an inventory only device. By default,
the inventory schedule is already configured.
Unlike scans for managed devices, you can only define an inventory only scan for the entire
Management Zone. In addition, you can run a scan only by using a schedule.
3.2.1 To Configure an Inventory Only Scan Schedule
1 In ZENworks Control Center, click Configuration , then in the Management Zone Settings
panel, click Inventory .
2 Click Inventory Only Schedule in the category list.
3 In the Schedule Type field, select what type of schedule you want to use.
No Schedule: No scan is scheduled. See “No Schedule” on page 55 .
Date Specific: Scans run on specified dates. See “Date Specific” on page 55 .
Recurring: Scans run on a recurring schedule. See “Recurring” on page 55 .