Novell EDIRECTORY 8.8 - GUIDE, Manual

Page: 476 / 574

SNMP Support for Novell eDirectory 477
no
vd
ocx (
E
NU)
01
F
ebr
ua
ry
200
6
ENABLE Enabling a trap refers to the NMS
receiving traps when they are
generated. dssnmpsa "ENABLE trapSpec "
trapSpec can be any one of the following:
To enable specific traps (for example, traps
10, 11, and 100):
dssnmpsa "ENABLE 10, 11, 100"
To enable all traps except 10, 11, and 100:
dssnmpsa "ENABLE ID != 10, 11, 100"
To enable all traps in the range 20 to 30:
dssnmpsa "ENABLE 20-29"
To enable all traps:
dssnmpsa "ENABLE ALL"
INTERVAL This utility is used to set and view the
time interval.
The time interval determines how
many seconds to delay before
sending duplicate traps.
The time interval should be between 0
and 2592000 seconds.
If the time interval is out of range, then
the default time interval is considered.
If the time interval is set to zero, all the
traps are sent.
To view the time interval:
dssnmpsa"213,240,79 INTERVAL"
To set the time interval between multiple
traps (for example, to set the time interval
between traps 12, 17, and 101 to 5):
dssnmpsa "12 17 101 INTERVAL 5"
To view the default time interval:
dssnmpsa "DEFAULT INTERVAL"
To set the default time interval:
dssnmpsa "DEFAULT INTERVAL = 10"
Trap Commands Description Usage