18
The play button plays the sequencer. While the transport is playing, the currently playing step is lit in
bright white. Press the Play button again to stop the sequence. The sequencer always starts from step
one when using the FLkey Mini’s transport section. You can move the start position using the mouse,
the FLkey Mini will use that as the start point.
You can use the Channel Rack up and down buttons Shift function, page
◀
and
▶
, to shift the
selection to the previous/next group of 16. A red box briefly highlights which set of steps you’ve
selected in FL Studio’s Channel Rack.
Channel Rack Graph Editor
This incorporates the pots into the pad mode. This allows you to edit properties of steps set in
sequencer mode. They map to the eight graph editor parameters from left to right (see table below
for more details).
To edit steps with additional parameters, hold the desired step on the pads and then turn the
appropriate pot. When you move a pot, the graph editor shows inside FL Studio and moves
correspondingly.
Pot/Knob
Graph Function
Pot 1
Note Pitch
Pot 2
Velocity
Pot 3
Release Velocity
Pot 4
Fine Pitch
Pot 5
Panning
Pot 6
Mod X
Pot 7
Mod Y
Pot 8
Shift
Custom Pad Mode
This pad mode gives you freedom over whichever parameters you wish to control. You can edit the
messages the pads send out in
Summary of Contents for FLkey Mini
Page 1: ...1 User Guide Version 4 0 ...
