Ex-Power DEFENDER – Operation and Maintenance Manual
Novatio Engineering Confidential Document
3-7
3.4
Stopping Engine
3.4.1
Emergency Stop
To stop engine in an emergency, turn Engine Switch (shown below) to the OFF position.
3.4.2
Stopping Engine Under Normal Conditions
1.
Turn off appliance(s) or tool(s) and disconnect from generator.
2.
Turn Engine Switch to OFF position.
Figure 3-2: Engine Switch and Emergency Off
3.
Allow engine to cool, and then turn the fuel tank cap vent lever to OFF position.
4.
If two generators were connected for parallel operation, disconnect the parallel operation
cables after stopping the engines, unless parallel operation is to resume. (Refer to Section
3.5.3 for details.)
3.5
AC Operation
Start the engine (see Section 3.3) and make sure the output indicator (green) comes on. Most
motorized appliances require more than their electrical rating for startup. When an electric
motor is started, the overload indicator (red) may come on. This is normal if the overload
indicator (red) goes off within 4 seconds. If the overload indicator (red) stays on, consult
Novatio.
Summary of Contents for Ex-Power DEFENDER
Page 44: ...NOTES...
