Novatel OEM7 SPAN, Installation And Operation User Manual, Page: 59 / 320

Chapter 2 SPAN Installation
OEM7 SPAN Installation and Operation User Manual v14 59
Make sure all of the pins on the header are aligned with the holes in the mating connector.
Press down on the MIC to seat the connector on the header.
5. Use the four screws supplied with MIC to secure the MIC card to the OEM719.
Figure 7: Mount the MIC on the OEM719
Connect the IMU to the MIC
1. Attach the IMU mounting Printed Circuit Board (PCB) to the IMU.
Ensure all the pins on the header are aligned with the holes on the mating connector.
An IMU mounting PCB is not used with the STIM300 IMU.
2. Connect the IMU-to-MIC interface cable to the IMU.
3. Connect the IMU-to-MIC interface cable to the IMU connector on the MIC.
l
Use the 10 pin locking connector (P701) for the ADIS-16488 IMUs.
See
Figure 10: Connect the ADIS-16488 IMU to the MIC (OEM Cable Kit: 01019007) on the next page.
l
Use the 20 pin locking connector (P601) for the HG1700, HG1900, HG1930 or STIM300 IMU.
See
Figure 8: Connect the HG1900 IMU to the MIC (OEM Cable Kit: 01018871) on the next page, Fig-