22
EuroPak-15a Receiver User Manual Rev 5
Chapter 1
Introduction
maintaining isolation between the DC and RF paths. The RF section can reject a high level of potential
interference (for example, MSAT, Inmarsat, cellular phone, and TV sub-harmonic signals).
1.7.2
Digital Electronics Section
The digital section of the receiver receives a down-converted, amplified GNSS signal which it digitizes and
processes to obtain a navigation solution (position, velocity and time). The digital section consists of an analog-
to-digital converter, a 32-bit system processor, memory, control and configuration logic, signal processing
circuitry, serial peripheral devices, and supporting circuitry.
The digital section performs the translations and calculations necessary to convert the IF analog signals into
usable position and status information. It also handles all I/O functions, including the auxiliary strobe signals,
which
are described in detail in
For input and output levels please see
1.8
Antenna or Signal Generator
The purpose of the antenna is to convert the electromagnetic waves transmitted by the satellites into RF signals.
An active antenna or a signal generator is required for the receiver to function properly.
Power for an antenna LNA is supplied by the receiver.
1.9
Principal Power Supply
A single external power supply capable of delivering 15 W is necessary to operate the receiver. See
A, Technical Specifications starting on Page 110
for details.
WARNING:
If the voltage supplied is below the minimum specification, the receiver will suspend
operation. If the voltage supplied is above the maximum specification, the receiver may
be permanently damaged, voiding your warranty.
1.10 Data Communications Equipment
A PC or other data communications equipment is necessary to communicate with the receiver and, if desired, to
store data generated by the receiver.
