NWB-DC IM 3 JAN 2014
© 2014 Novatec, Inc. All Rights Reserved
Page 8
NWB-DC IM 3 JAN 2014
3.0 ASSEMBLY INSTRUCTIONS
3.1 Prepare/Assemble Machine Mount Receiver
NOTE: As you proceed with assembly, make sure that all bolts and hose clamps are securely fastened to
ensure that there are no air or material leaks in the system. Do not
use excessive flex hose but avoid sharp turns as this will hurt the
efficiency of the system operation.
3.2 Mount Hopper Receiver & Connect Flex Hose and Pickup Wand
1-A
: If Machine Mount Receiver base has not been pre-drilled,
remove base from Machine Mount Receiver and drill holes
to match machine throat hole pattern and re-attach base to
MM Receiver.
1-B
: Attach Photo Eye Level Sensor to the bracket provided.
1-C
: Connect 115/1/50-60 VAC wiring to twist lock plug.
(supplied)
2-A
: Remove cover plate from top of Material Hopper
(save bolts and washers) then,
after removing
masking tape from flapper
, place Hopper
Receiver in hole. Align inlet stub to face direction
from where material will be pulled. Fasten the
Receiver to the Hopper using the saved ¼” x 20
bolts and washers.
2-B
: Place hose clamp over one end of flex hose and
push end of the hose on to the material inlet stub
on the side of the receiver. Fasten hose clamp
securely.
2-C
:
Cut the flex hose to a length that will allow the
5’ long pickup wand to reach all corners of the
bulk container supplying the material to the
dryer hopper.
Push the cut end of the flex hose
over the end of the pickup wand and secure with
hose clamp.
2-D
: Follow same instructions to attach flex hose
running from the vacuum stub on top of the
Hopper Receiver
to the nearest EPV Dual
Station Vacuum Valve Stub extending from
the top of the dryer.
(See illustration)
1-A
1-B
1-C
1-A
Tools You Will Need for Assembly:
Hacksaw to cut PVC flex hose
Flat Blade Screwdriver and/or 5/16” socket for hose clamps
5/32” Allen wrench to mount Receivers
Drill press and drill bit sized to match mounting holes on machine throat so holes
can be drilled in base of Machine Mount Receiver. (Unless base is pre-drilled)
6’-8’ Ladder
Tape measure
Photo Eye Level
Sensor
2-A
2-B
2-D
2-C