NWB-DC IM 3 JAN 2014
© 2014 Novatec, Inc. All Rights Reserved
Page 28
NWB-DC IM 3 JAN 2014
The NOVATEC MENU can be seen by
touching the upper LH corner of any other
screen. It can only be accessed with a
NOVATEC password. The screen contains
the software revision level (in the case of a
standard) or the program number (in the
case of a custom) for both the touch screen
and PLC. The Runtime Control Panel
releases the dryer program and goes to the
touch panel set up program. Other touch
buttons allow access to special set up
screens. For instance, Calibrate Touch
Screen allows set up of the touch pressure
that will cause the screen to respond to the
operator’s finger.
18.0 NOVATEC SCREENS
18.1 Basic Machine Configuration
There are 3 Basic Configurations. These are set at the factory prior to shipping.
18.1.2 Configuration Menu 1
1
8.1.3 Configuration Menu 2
Changing from F° to C° is a common
reason to access this screen.
Obtain password from NOVATEC.
Press in upper LH corner of any screen
to view NOVATEC Menu. Enter
NOVATEC Password. Press Basic
Machine Configuration then
Configuration Menu 1. Press F° and it
will change to C°.
This screen allows you to install the options for 1
or 2 drying hoppers, whether they have active
drying, offset the thermocouple if there is an
error, and to filter the response if the
thermocouple is noisy.
To enter a thermocouple
Offset , entering a -5.0 will raise the reading 5
degrees. Entering a 5.0 will lower the reading 5
degrees.
Valid entries for the filter are between 1.0 and
0.01. Contact Novatec Engineering before
changing the settings.