NWB-DC IM 3 JAN 2014
© 2014 Novatec, Inc. All Rights Reserved
Page 25
NWB-DC IM 3 JAN 2014
The Password Entry screen will appear whenever
the system is directed to a screen that has
password protection associated with it. If the
password is enabled, the screen will remain up until
the correct password is entered. If the password is
not enabled, the screen will appear briefly before
continuing to the selected screen.
The Password Menu Screen has listed 6 other
screens with a space for passwords and a
selector pad to either enable or disable the
password. Any 5-digit number may be set as a
password. To enable the password and protect
the screen, enter the password and depress the
associated pad. The
pad will show “Enabled”
and the protection will become active after
leaving this screen.
Here, the process values for the material to be
dried can be set or adjusted. The high and low
deviation, (range for the alarm) second set point,
and active set point values are available. Values
must be entered as positive values.
The Overtemp SP is the temperature, at which,
the hopper blower and temperature control will
shut down.
NOTE: If you change the factory pre-set
values (which are fine for just about any
drying scenario) they will apply to every resin
you dry so be sure to re-enter the factory
pre-sets.
17.2.2 Password Menu
17.2.3 Password Entry
17.2.4 Process Menu
375