NWB-DC IM 3 JAN 2014
© 2014 Novatec, Inc. All Rights Reserved
Page 21
NWB-DC IM 3 JAN 2014
1
16.0 DRYING MATERIAL
16.1 Initial Dryer Startup
NOTE:
Assure voltage, connection and phasing are correct, cooling water is supplied (for dying over
225°F) and thermocouple is inserted in hopper. Connect material source to Hopper Receiver.
Turn Main Disconnect Switch to
“ON” position and Quick Op screen (below) will appear.
Check the Time pre-sets. If changes are required, press MENU, near above, then press
Dryer Setup then Clock Setup.
Set clock so alarms will have correct date & time stamp.
Press Gray button to enable changes.
Press each button where a change is required and keypad will appear.
Make entry, then press
after each entry. Continue until all fields are correct.
Enable Daylight Savings Correction if applicable
Press gray button to start clock. Then to return to Quick-Op screen.
Auto Start/Stop can be set, if required. See Instruction Manual page 24.
Press Hopper Receiver icon to access Hopper Loading screen.
Enter desired values and press to start loading hopper from
material source previously set up. Press BACK arrow.
v
v
v
v
6
v
2
3
3
4
v
v
3
4
5
5
7
7
v
v
6
6
NOTE: There are no factory
default passwords except to
access the NOVATEC,
restricted use screens. You can
set passwords for specific
functions. See page 25.
v
5