NWB-DC IM 3 JAN 2014
© 2014 Novatec, Inc. All Rights Reserved
Page 10
NWB-DC IM 3 JAN 2014
4.0 ELECTRICAL CONNECTIONS
The NWB-DC Series dryers come from the factory with all control circuits wired and
a 10’ power
cord. A quick-connect plug should be installed if moving the NWB-DC to other process
machines is anticipated.
CAUTION
All electrical connections must be made by qualified electricians, per national
and local electrical codes.
Disconnect and lock out the main power source before making the electrical connection.
Turn the Main Disconnect on the electrical panel
door to the “OFF” position, lock out the
main power source and open the electrical enclosure. Per the electrical diagram, install
the main power wire to the main disconnect switch holder and install the ground wire.
Full size electrical drawings are included with this Instruction package for the voltage
of the dryer you ordered.
460V/3Ph/60H
NOTE: Please make sure all electrical connections are tight. It is not common
but a loose connection is possible after a long truck ride.
NOTE: 3 Phase detection is included on this model. If the
connection is not correct, a pop-up alarm will appear on the
touch screen upon startup. You should immediately correct
this condition.