LED Display Controller Thunderview_S1
User Manual
6 Operations
www.novastar.tech
12
6.6.5 Redundancy
Set the current device as the primary or backup device.
6.6.6 Factory Reset
Reset the current device to factory settings.
6.6.7 Returning to Home Screen
Set the period of time during which the system stays at the current screen before
returning to the home screen automatically when there is no operation performed at
the front panel.
6.6.8 OLED Brightness
Adjust the OLED brightness which ranges from 5 to 15.
6.6.9 Hardware Version
The user can view the hardware version of the current device. If a new version is
released, the user can log in to NovaLCT on the PC to view the version and update
the firmware programs.
6.7 Communication Settings
Set the communication mode and network parameters of the S1.
Communication Modes
Two communication modes:
USB Preferred
and
LAN Preferred
When the USB and Ethernet control ports are connected at the same time, the system
will use the communication mode set by the user.
Network Settings
The network (
Config IPv4
) can be set manually or automatically.
When setting the network automatically, the user can only reset the network
parameters.
When setting the network manually, the user can set the device's IP address (cannot
conflict with IP addresses of other devices) and subnet mask, or reset the network
parameters.
6.8 Language
Change the user interface language of the device.
XI'AN
NOVASTAR
TECH
CO.,
LTD.
