Novanta v40, User Manual

Page: 41 / 104

OEM CONTROLS AND INDICATORS PAGE | 41
4 RDY (Ready) Indicator – illuminates yellow when the laser is enabled, indicating that, after a five-
second delay, lasing will begin when a PWM Command signal is applied.
5 SHT (Shutter) Indicator – illuminates blue to indicate that the shutter is Open, and that lasing
may be enabled. The SHT indicator is off, and lasing is disabled if the shutter is Closed. When the
shutter is switched Open, there is a five-second delay until PWM inputs are recognized.
6 LASE Indicator – illuminates red to indicate that is actively lasing. The LASE indicator is off when
tickle pulses are being generated and illuminates red when PWM Command signal pulses are long
enough to produce laser output.
7 Keyswitch – enables/disables operation of the laser. The laser is enabled when the Keyswitch is
turned to the ON position. Turn the Keyswitch OFF to disable lasing.
8 USER I/O Connector – provides a connection point for auxiliary output power as well as input
and output signals. Refer to the Technical Reference chapter for pinouts and signal descriptions.
9 WATER IN Port (water-cooled only) – labeled IN, this connection provides the cooling water
inlet to ’s water-cooling system.
10 WATER OUT Port (water-cooled only) – labeled OUT, this connection provides the cooling
water outlet from ’s water-cooling system.
OEM controls and indicators
OEM v40 side panel (SAB models)
Figure 3-3 OEM v40 side panel controls and indicators
1 DB-9 connector – provides a Shutter Switch input as well as aux5 and +24 VDC outputs.
See DB-9 connections in the Technical Reference chapter for connection details.