Novanta Precession Elephant 2, User Manual

Page: 26 / 103

PRECESSION ELEPHANT 2 Scan Head 2 Instruction Manual 2021-09-22
Table 5: Legend to Figure 3
No. Label / description Action
① LASER Connect by provided cable and (if applicable) laser
adapter to the laser.
If your laser device is supported by the InScript
software then find more information in [
Firmware ] in
section
Devices:Laser  <your laser>
.
If your laser device is not supported then find
information in [
Firmware ] in section
Devices:Laser 
ConigurableLaser
.
For further information see [ ASC ] and (if applicable)
the corresponding laser adapter manual and the laser
manual.
② AC input;
Connector IEC-60320 C14 Connect by mains cable to mains.
③ Grounding;
Screw M5 Additionally to the grounding through the AC input
connector
②
ground the ASC via this grounding
point.
④ SCAN HEAD POWER Connect by provided power cable to the DC INPUT
connector at the scan head.
⑤ SCAN HEAD DATA A Connect by provided CAT-5 patch cable to the DATA
I/O connector at the scan head.
⑥
ETHERNET
Connect by provided CAT-5 patch cable via Ethernet
to the PC where the InScript software is installed.
For further information see the reference [
ASC ].
5.5 How to use the cooling water quick coupling
Please find the cooling water specification in Table 4 on page 21 .
26