Novanta JADAK FM-8, User Manual

Page: 62 / 89

JADAK FM-8/FM-9 User’s Manual
2D Matrix Symbologies
Aztec Code
Aztec Code Defaults
To set the default values for Aztec Code, scan this code:
Aztec Code On/Off
Scan one of the codes below to enable or disable Aztec Code. Default = Enabled.
* Enable Disable
Aztec Code Minimum and Maximum Length
Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Aztec barcodes.
Default minimum length = 1. Default maximum length = 3832.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 3832, or
by scanning one of the barcodes below and then set the length by scanning the digit
codes and the SAVE barcode in
Appendix B
.
Please contact JADAK if assistance is needed.
Aztec Code Minimum length Aztec Code Maximum length