FIRMWARE UPGRADE PROCEDURE
PAGE
|
91
Connect to the i401 laser
1
Remove DC power from the laser.
2
Locate the Ethernet crossover cable in the ship kit and connect it between your computer
and the i401’s Ethernet port.
3
Remove the Quick Start Plug from the i401’s User I/O connector.
4
Apply 48 VDC power to the laser and wait 15 seconds for the firmware to initialize.
5
If you have changed the i401’s IP address (the factory default is 192.168.50.50), you must
change it back. If not, proceed to the next section, Perform the firmware upgrade.
A
Launch your web browser, type the laser’s IP address, and then press Enter.
B
When the home page appears as shown in Figure below, click the Configure IP
Address link at the bottom of the page.
Figure 4-25 Configure IP Address link on I401 home page
C
When the Change IP Address page loads showing the default IP address (following
figure),
click the Submit button. This resets the laser’s IP address to 192.168.50.50.
Figure 4-26 i401 Change IP Address page
