MicroE Optira Installation Manual
Celera Motion
IM-1001 | REV181211
Page 29
©2018 Celera Motion
11.2 Cutting Tape Scales
Note
: When working with any encoder scales, it is important to use finger cots or talc-free
gloves.
Step
Action
1. Uncoil the tape scale and cut it to the required length using the shears provided in the
installation kit.
Note
: Check interface drawing to make sure that the scale is cut to the correct length.
2. Securely hold the tape scale close to the shears (at an approximate distance of 40 mm [1½
inches]) near the point of cutting. Orient the tape scale perpendicular to the shear.
Cut the tape scale in a smooth, continuous motion.
Shear held perpendicular to the
tape scale (not inclined
)
Hand approximately at a distance of 40 mm-50 mm
(1 1/2 inches to 2 inches) from the cutting point
Shears held inclined, not
perpendicular, to the tape scale
