Notifier NFS-3030/E, Programming Manual

Page: 34 / 144

Program Point Program
34 NFS-3030 Programming Manual P/N 51345:C 11/4/03
3.4 Point Program
The Point Program allows the programmer to enter/change point information for detectors,
modules, panel circuits, and general, releasing, logic and trouble zones.
Press the Point Programming Menu soft key of the Program/Alter Status Menu to display the
screen below.
Figure 3.22 Point Program Menu
Soft Keys
POINT SELECT:
Press until the desired point type appears. The types - detector, module, panel
circuit module, general zone, logic zone, trouble zone, or ACS Board - appear in the parenthesis
after the point formats. Enter the desired point address in the format field.
ACCEPT:
Press to progress to the appropriate screen, based on the type of point selected.
NEXT/PREVIOUS SELECTION:
Press to scroll backward or forward to the next or previously
installed point.
P O I N T P R O G R A M M E N U
P O I N T S E L E C T :
L y y D z z z ( D E T E C T O R )
N E X T S E L E C T I O N A C C E P T
P R E V I O U S S E L E C T I O N B A C K
www.PDF-Zoo.com