ID50 Series Panel - Installation, Commissioning & Configuration Manual
Configuration
Mode
48
997-263, Issue 4
September 2002
5.5.19 Day Mode Activity
The Day mode function enables the panel to switch
between two (2) preset sensitivity levels. Day mode is
set for one time period per day for seven days unless the
Weekend night mode is also configured (
Section 5.5.20,
Weekend night mode
). It also allows the manual
activation/deactivation of delayed outputs during the set
Day mode period. To configure the Day mode period:
1
From the Commissioning menu, using the numeric
keypad press the
1
button to enter the Setup menu.
2
Press the
2
/
8
buttons to step through the Setup
menu until the Day mode activity menu is displayed.
3
Press the
6
button to prompt for a start time at
which this function will be enabled.
4
Using the numeric keypad, enter the appropriate time
in the 24-hour clock format and confirm using the
5
button.
5
The LCD displays a prompt to enter an end Day mode
time. Use the numeric keypad to enter the appropriate
time in the 24-hour clock format and confirm using
the
5
button.
6
Press
4
to save all changes and return to the main
Commissioning menu.
To disable Day mode
1
With the Day mode activity menu displayed, press the
1
button on the numeric keypad.
2
Press
4
to exit and return to the Commissioning
menu.
[Setup]
Day mode activity = DISABLED
> : Change
1 : Disable
×
: More
< : Exit
[Setup]
Day mode activity = DISABLED
Enter start time :
-0:00
< : Cancel
[Setup]
Day mode activity = DISABLED
Enter start time :
07:46
< : Cancel
[Setup]
Day mode activity = DISABLED
Enter finish time :
-0:00
< : Cancel
[Setup]
Day mode activity = 07:46-> 18:12
> : Change
1 : Disable
×
: More
< : Exit
[Setup]
Day mode activity = 07:46-> 18:12
> : Change
1 : Disable
×
: More
< : Exit
[Setup]
Day mode activity = DISABLED
> : Change
1 : Disable
×
: More
< : Exit
[Setup] Language =
English
> : Change
×
: More
< : Exit
1
or
8
2
6
1
