1 I56-5917-000
INSTALLATION AND MAINTENANCE INSTRUCTIONS
Model FS-BSO
Addressable Base Sounder
Notifier by Honeywell
9 Columbia Way Baulkham Hills,NSW 2153
Australia
www.notifier.com.au
SPECIFICATION
Item
Parameter Description
Note
Operating Voltage
24VDC( 15 to 32VDC)
Avg. Standby Current
<400µA
24VDC, No Communication, No sounding
Alarm Current
<6mA High
Volume,
24VDC
<4mA
Low Volume, 24VDC
Operating Temp
-10
℃
to +55
℃
Humidity
10 to 95% R.H.
Non-condensing
Ingress Protection
IP21C
Approved Sound Pressure
Level
83±4dB(A)
1m , High Volume, Tone 21 @24V(2.7mA) *Approved to EN54-3
High Volume .
Most Favorable Sound
Pressure Position
92±3dB(A)
1m , 90°,High Volume, Tone 21 @24V(2.7mA) **
94±4dB(A)
1m , 90°,High Volume, Tone 13 @24V(3.0mA) **
95±3dB(A)
1m , 90°,High Volume, Tone 12 @24V(2.5mA) **
94±7dB(A)
1m , 90°,High Volume, Tone 19 @24V(2.5mA) **
Low Volume .
Most Favorable Sound
Pressure Position
88±3dB(A)
1m , 90°, Low Volume, Tone 21 @24V(2.0mA) **
88±3dB(A)
1m , 90°,Low Volume, Tone 13 @24V(2.0mA) **
85±4dB(A)
1m , 90°,Low Volume, Tone 12 @24V(1.7mA) **
85±5dB(A)
1m , 90°,Low Volume, Tone 19 @24V(1.8mA) **
Tone Type
4
See table 1: ‘Sound setting ’ for detailed tones
Height 52mm
Diameter 122mm
Weight 196±6g
Note: * Detailed description see table A
**These volume & tone settings are not approved to EN54-3.
Meet the following Standards requirements
：
EN54-3
，
AS ISO 7240.3:2014
Before installing and using the product, please read the system wiring
and installation manual thoroughly. If the products will be installed in an
existing operational system, inform
the operator and local authority that
the system will be temporarily out of service, disconnect
power to the
control panel before installing the products.
NOTICE: This manual should be left with the owner/user of this
equipment.
GENERAL
FS-BSO is an intelligent addressable AV base designed to alarm sound for
emergency events, and be able to communicate with control panel by
intelligent protocol.
It is designed specifically for analogue addressable fire alarm system
and only can be connected to control panels with a compatible
proprietary analogue addressable communication protocol. It is
powered from the loop and can be controlled via the communication
protocol(s). The Base version is compatible with 200 series of
detectors and B501 mounting base. Up to 159 addresses are available
via two rotary selector switches. The sounders have 2 volume levels
(high/low) and 4 tone sets. The alarm sound can be tested on field.
INSTALLATION
It must be installed and wired with B501 mounting base.
1.
Verify the product type matches with product drawing.
2.
Set the address via two rotary selector switches. Please refer to
“Address setting”.
3.
Volume and tone setting are realized by 4 digit DIP switch. On field
testing can be tested via DIP switch.
4.
Plug the Sounder base into B501 mounting base.
5.
Turn the Sounder base clockwise until it drops into place.
6.
Continue turning the Sounder base clockwise to lock it in place.
7.
Please refer to Detector Installation Instruction if 200 series
detector is needed.
SETTING
Address setting
Rotary-decade switches are provided for setting the base’s address
whose range is from 1 to 159. (Default address is 01).
Address is set by turning the switches.
Address is calculated as below formula: Address = TENS *10 +
ONES*1. For instance: Address 05 = 0*10 + 5*1.
Tamper-resistant capability
Addressable Base sounder include a tamper-resistant capability that
prevents its removal from the B501 base and the removal of installed
detector without the use of a tool.
When B501 mounting base enables tamper-resistant function, special
tools must be used to disassemble addressable base. Please refer to
below figure: use straight screwdriver to break specific position, then
insert the screwdriver and maintain in its position. Then you can
disassemble the Sounder base by turning anticlockwise
Figure 1
Figure 2
I5
6
-59
17-
000
A5665‐001
Base
Sounder
B501
Mounting
200 Series
Detector
A5665‐002
ONES
DIP switch for
tone setting
COMM+
COMM-
TENS
RA Remote
Annunciator
