Norwood Kwik-Till HSD1600, Operator'S Manual, Page: 47 / 152

3 - TRANSPORT OPERATIONS
3-5
Preparing Kwik-Till
Drawbar Requirements
IMPORTANT
Tractor drawbars must be compatible with the Kwik-
Till hitch links or damage to machine and/or tractor
can occur. Refer to the tractor Operator’s Manual for
specific drawbar requirements. For ordering hitch
links see your Kwik-Till dealer, for hitch pins, see your
tractor dealer or qualified service provider. Do not
exceed static vertical load capacity of tractor drawbar.
See Specifications section
(See “Downward Force on
Tractor Drawbar” on page 7-1)
for vertical load and
see tractor operator’s manual for drawbar limits and
heavy-duty supports.
B
A
Fig. # 3-8 Determining Drawbar Hitch Link Size
Hitch
Category
Tractor Drawbar
Hitch Pin
Diameter (A)
Drawbar Opening
Height (B)
4
2.0 in
(51 mm)
3.54 in
(90 mm)
5
2.75 in
(71 mm)
3.94 in
(100 mm)
Fig. # 3-9 Table: Determining Drawbar Hitch Link Size
(Non-Articulating Ball)
Cat. 4 Hitch Link
(Max. Hitch Pin
2" (51 mm) Dia. )
P/N 90-42-0012
Fig. # 3-10 Cat. 4 Hitch Link, Non Articulat-
ing Ball, Standard For HSD2500, & HSD3000
(Max Dia. Hitch Pin Ø2.0 (51 mm))
Fig. # 3-11 Cat. 5 Hitch Link, Non Articulating Ball, Stan-
dard For HSD3500, HSD4000, & HSD4500 (Min. Hitch Pin
Dia. Ø2.0” (51 mm)) (Max. Hitch Pin Dia. Ø2.75” (71 mm))
P/N 90-42-0026
Cat. 5 Hitch Link
(Min. Hitch Pin Dia.
2" (51 mm))
(Max. Hitch Pin Dia.
2-3/4" (71 mm))
P/N 90-42-0026