Page 10 of 14
Do not lift heavy parts or assemblies. Use a crane jack, block and tackle, forklift, or other
mechanical lifting device.
Never put hands or any other body part under blocked-up assemblies, if at all possible.
After completing assembly, thoroughly inspect the machine to be sure that all nuts, bolts,
hydraulics, fittings, or any other fastened assemblies have been thoroughly tightened.
Stay alert, watch what you are doing, and use common sense when operating this machine. Do
not operate while you are tired or under the influence of drugs, alcohol, or medication. A moment
of inattention while operating may result in serious personal injury.
Use safety apparel and equipment. Use safety goggles or safety glasses with side shields which
comply with current national standards, or when needed, a face shield. Use as a dust mask in
dusty work conditions. Also use non-skid safety shoes, hardhat, gloves, dust collection systems,
and hearing protection when appropriate.
Keep alert and watch the front as well as the rear when working with the implement.
Do not operate close to ditches or creeks. Slow down when operating over rough ground.
Always be sure the implement is in the fully raised position when in transport.
When removing, changing the angle, or reversing the rake, be sure that your feet are never under
the rake.
Use extreme caution when backfilling deep holes and trenches.
Be careful to avoid catching the rake on stumps or other immovable objects.
Use care when working on slopes.
Avoid excessive speed during operation.
Make adjustments only when the rake is attached to the tractor.
When using the rake in a reverse position, use extra care. Do not ram the rake into piles of dirt.
Both the tractor lift arms and the rake are not built to take high-impact loads in this position.
Ramming backwards can also dislodge operator from seat and/or tractor controls, resulting in
possible serious injury or death.
The spring steel rake tines in operation may suddenly fling rocks and clods of earth. Keep all
bystanders 25 feet or more away from an operating rake.
Before operating equipment
— If you have any questions regarding the proper assembly or
operations, contact your dealer or the manufacturer.
Maintenance
Clean, inspect, service, and make necessary repairs to the rake when parking it for long periods and
when parking it at the end of a working season. This will help ensure that the rake is ready for field
use the next time you hook up to it. Clean off any dirt or grease that may have accumulated on the
rake. Scrape off compacted dirt and then wash the surface thoroughly with a garden hose.
1. Inspect the rake for loose, damaged, or worn parts. Adjust and tighten loose parts or replace if
necessary.
2. Clean dirt, oil, and grease from areas where the paint has been worn, chipped, or scratched.
Prime any bare metal surfaces after cleaning and repaint to prevent rust.
3. A light coat of oil or grease may be applied to the cutting blade to minimize oxidation.
4. Follow the unhooking instructions when disconnecting the rake from the tractor.