Network Video Recorder
User Manual
Install device
12
Issue: V4.6.X(2022-04-24)
Step 1
Check the appearance, packaging, and label of the device to make sure there is no
damage.
Step 2
Install the hard disk and fix it to the device bracket.
Step 3
Connect the device cable.
Step 4
Make sure the device is properly connected. Power up and turn on the device.
Step 5
Configure the initial parameters of the device. The boot wizard contains network
configuration, add cameras, and manage disks. For details, please refer to the chapter of
Wizard .
3.2
Unpacking I
nspection
When you receive the video recorder, please check it against the following table.
Should you have any issues, please don't hesitate to contact our after-sales support.
Table 3-1
Unpacking inspection
No
Item
Check content
1
Overall
packaging
Appearance
Is there any obvious damage
Package
Is there accidental impact
Accessories
Is it complete
2
Label
Label of device
Is the equipment model consistent with the
order contract?
Whether the label is torn
Do not tear or discard, otherwise warranty service is not
guaranteed. When you call the company for sales personnel
calls, you need to provide the serial number of the product
on the label.
3
Cabinet
Package
Is there any obvious damage
Data cable, power
cable, fan power supply,
and motherboard
Is the connection loose?
If it is loose, please contact the company's after-sales
personnel.
3.3
Install Hard Disk
Check if the hard disk is installed during the first installation. Please use the recommended hard
disk model. It is not recommended to use a PC dedicated hard disk.