Northern Meditec Crius V6, Operator'S Manual

Page: 68 / 182

68 / 182
The system check screen displays the last system check time. Select the [ Details ] button to
query the system check information of the ventilator system, including system check items,
System Check results, and System Check time.
Connect the gas supply and block the Y piece as illustrated. Then select [ Continue ] to start System
Check item by item.
System Check items include:

Hardware Voltage

Sensor

Calibration Date

Inhale Valve&Exhale Valve

Blower

O
2
Valve

Hardware Comm.

Compliance
System Check result can be:

Pass: indicates that check of this item is completed and is passed;

Fail: indicates that check of this item is completed but is failed;

Cancel: indicates that check of this item is cancelled;

O
2
Supply Failure: indicates that O
2
supply is insufficient when O
2
sensor test or O
2
flow sensor test is being carried out;

Monitoring Off: indicates that sensor monitoring function may not be switched on when O
2
sensor test is being carried out.
During System Check, the system prompts [ Running ] on the right side of the current check
item. In this case, if you select [ Skip ], the system stops the check of this item immediately and
displays [ Cancel ] as the check result. The check of the next item begins at the same time. If
you select [ Stop ], the system stops the check of the current item and also the check of the
remaining items immediately, and displays [ Cancel ] as the check result.
When O
2
sensor test fails, the [ O
2
Calibration ] button is displayed. Press this button to open
the O
2
calibration menu, and then to calibrate oxygen concentration.
When checks of all items are completed, if you select [ Retry ], the system starts a new round
of checking. If you select [ Exit ], the system exits the check and enters Standby status.
6.3 Select Patient