
1
M1574210B
Owner’s Manual
Electric Hot Water/Steam Pressure Washer
Instructions for Set-up, Operation, Maintenance & Storage
Portable Outdoor
–
Use Only
This pressure washer produces both cold and hot water high-pressure spray as well as wet steam. Cleaning
chemicals may be incorporated into the spray if desired. The pressure pump for this equipment is powered
by an electric motor and the water is heated by a diesel, kerosene/fuel-oil fired, down draft burner.
WARNING: SPECIAL HAZARDS
•
Skin/Eye Injury
: High-pressure spray can cause serious skin or eye injury, including injection injury if fluid pierces the skin.
Injection injury can result in blood poisoning and/or severe tissue damage.
•
Burns
: Hot spray can scald and burn skin. Hot surfaces of wand and burner, as well as hot exhaust from the burner can
cause burns.
•
Slips/Falls
: Spray discharge can cause puddles and slippery surfaces. Spray-gun kickback can cause operator loss of
balance and falls.
•
Flying Debris
: High-pressure spray can cause surface damage and flying debris.
•
Fire/Explosion
: Burner sparking can ignite fuel or other flammable liquids or vapors in the vicinity. Hot exhaust from burner
can ignite combustible materials.
•
Chemical Exposure
: Cleaning chemical vapors or contact with skin may be hazardous.
•
Electric shock
: Spray contact with electrical sources can cause electric shock.
•
Electrocution
: Improper connection of the equipment or grounding conductor can result in a risk of electrocution.
•
CO Poisoning
: Exhaust from burner contains carbon monoxide, a poisonous gas that can cause carbon monoxide poisoning
and possible death if inhaled.
Equipment Protection Quick Facts
Inspect Upon Delivery:
STOP! Closely inspect to make sure no components are missing or damaged. For missing
or damaged components please contact Product Support at 1-800-270-0810.
Check Pump Oil:
Pump is shipped with oil. Check pump oil level before starting.
-
Remove shipping tape and black vent plug (if present) from pump oil fill cap (CAT Pumps)
-
Pump is supplied with Vented fill cap (General Pumps only)
Water Flow Requirements:
Make sure your supply water flow rate is 20% higher than the pressure washer’s flow
rate (See Specification Section for unit specific flow rates), and that your water is clean and particle free.
Chemical Spraying:
Use only NorthStar brand or equivalent washer chemicals designed for pressure washer use.
Maintenance Schedule:
Pump, burner fuel filter, burner coil and electrodes require periodic checking and servicing
to keep pressure washer functioning efficiently. See
“
Maintenance & Repair
”
for frequency of servicing.
Any Questions, Comments, Problems or Parts Orders
Call NorthStar Product Support 1-800-270-0810
ITEM NUMBER: 1574210, 1574211,
1574212, 1574213
SERIAL NUMBER: _____________
Summary of Contents for 1574210
Page 48: ...48 Pump Explosion CAT 4DX...