Nortel RLC, Installation And Administration Manual

Page: 356 / 466

330 RLC Installation and Administration Guide
Planning forms Standard 4.0
Reach Line Card
Connection Information—16 ports
Complete one copy of this form for each line card.
Page 1 of 5
RLC information
IPE position: Loop:________ Shelf: _______________ Card:____________
IP address:
Subnet mask:
Default gateway:
Host PBX’s ELAN IP address:
Host PBX’s ELAN subnet mask:
Security level:
❒
No security is required
❒
Caller ID
❒
Provisioned Security*
*If the security level is provisioned security, RLC’s security identifier:
Inbound
Outbound
Notes:
„
This RLC provides 32 total ports. Ports 0–15 are Voice ports and ports 16–31 are Data ports. On
the host PBX, you must configure Network ports or Remote ports that use MCAs or ATAs (for
data transmission) as Data ports. If there are not enough free Data ports, you can configure
Remote ports that use ATAs as Voice ports. You can configure Remote ports used for FAX
support as either Voice ports or Data ports. Refer to documentation for your PBX for necessary
procedures.
„
QoS Transition Technology requires one MCA per B-channel.
„
If you want to use MCAs or ATAs to transmit data, you can connect a maximum of four MCAs or
ATAs to Remote ports on this RLC.